Cedar Torque Meter (CD Series)

Share:


Cedar Torque Meter (CD Series)

Torque Meter CD series General Measurement Method for Torque Tester for daily inspection of Electric Screwdriver by MSP Metrology (M) Sdn Bhd from Cedar Japan.


Feature
CD-100M/10M

Suitable for daily inspection of electric screw driver
Using convensional joint (SJ joint (PAT))
Enable to save 5 channels of pass/fail judgement criterion, and enable to change settings by switch channels even if the tightening term changes.
High durability against high torque loaded unexpectedly. (triple the durability of conventional model).
Also, the attached adapter does not disassemble the joint due to excessive rewinding.It can be used and managed in a conventional way.

The best for everyday check of an electric driver

- Everyday check of an electric driver can be performed.
- Since various informationis displayed on a display board, it is very intelligible.
- The change of a measurement unit can be performed.
- Memory data is 800 affairs.
- Real-time output, every about 1/180 seconds
- The taking-in software of data can download from a homepage.

- Show “Measurement mode”, “Measurement unit”, “maximum, minimum, average”
- Switchable measurement unit
- Enable to save 5 sets of settings such as upper limit and lower limit
- 800 items of memory data
- Real-time output About every 1/180 seconds
- Data acquisition software can be downloaded for free

Yes-No Decision Conditions, Etc. Can Save Five Channels

- A channel is only changed even if bolting conditions change.
- It is not necessary to reset up a maximum value and a minimum value one by one like former.

Specifications

Specification CD-100M CD-10M
Measuring Range

– 0.10 ~ 10.00 Nm

-1.0 ~ 100.0 kgf.cm

– 1.0 ~ 90 lbf.in

– 0.010 ~ 1.000 Nm

-0.10 ~ 10.00 kgf.cm

– 0.10 ~ 9.000 lbf.in

Accuracy ±0.5% (199 digit or less ± 1 digit)
Display The 3.5 figures digital display of LCD
The Measurement Direction CW-CCW (right and left)
Zero Return By One Touch Return to zero by pressing clear button
Measurement Mode Track, P-P(peak to peak), P-D(peak-down), C(real-time output)
High and Low Limits Judging Function High and low valuee are measurement within the limits, and can be set up
Real-Time Output Load torque value is outputted every about 1/180 second
The Maximum, The Minimum, and The Average Value Display The maximum, the minimum, average value
Data Output ASCH format (baud rate 19200)
Auto Power Save 10 minutes no use, automatically switch off
Power Supply  Ni-Cd chargeable battery 1.2V x 5 cells 700mAh
Charging Time About 3 hours
Continuous Working Time About 12 Hours
Clearence It is a display clearance in set-up time (0.1- 0.3 sec)
Socket Size 20mm / 9.5mm
Dimension / Weight  W: 160 x D: 125 x H: 55 / About 1kg
Recommend Buffer Accessories Measuring Joint SJ-50,SJ-10K Measuring Joint SJ-10
AC/DC adaptor
Exclusive receipt case
An inspection report, a proofreading certificate, a traceability system figure


 Inquiry - Cedar Torque Meter (CD Series)

GET IN TOUCH
10, Jalan Gemilang 9, Taman Perindustrian Cemerlang, 81800 Ulu Tiram, Johor, Malaysia.
+607-862 6772
STAY CONNECTED
LIKE & FOLLOW US